[. . . ] Nokia Holder Easy Mount HH-20 and CR-116/117 1 B D C E A 9218602/2 2 A D C F G E B 3 4 5 6 7 10 9 8 11 ENGLISH © 2009-2010 Nokia. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation. Introduction The Nokia Holder Easy Mount HH-20 is a mounting device that allows you to attach your compatible mobile holder to the windscreen or, using the optional adhesive pad, to the dashboard of your vehicle. [. . . ] For your safety, install the holder in the upright position. Attach to a windscreen Attach the holder to the mounting device To attach the mobile holder to the mounting device, insert the catch on the mounting device into the slot at the back of the holder (see step 1A at the start of this guide). Rotate the holder clockwise about 90 degrees until it locks into place (1B). To detach the holder from the mounting device, rotate it anticlockwise. Attach the mounting device to the windscreen Before you attach the mounting device to the windscreen, locate a safe mounting surface on the windscreen, ENGLISH and clean the surface thoroughly with a glass cleaner and a clean towel. If the ambient temperature is below +15°C (60°F), carefully warm the surface and the suction cup with a hair dryer to ensure a firm grip on the windscreen. Ensure that you do not heat the windscreen excessively to avoid damage to it. Press the suction cup of the mounting device against the windscreen (see step 1C), and rotate the ring on the mounting device clockwise (1D) to create a vacuum between the suction cup and the windscreen. To detach the suction cup from the windscreen, rotate the ring on the mounting device anticlockwise (9), pull the strap located on the edge of the suction cup (10), and pull the holder with the mounting device from the windscreen (11). Attach to a dashboard Attach the mounting device to the dashboard If the product was supplied with an adhesive pad, you can attach the mounting device to the dashboard. Ensure that the surface where you attach the adhesive pad on the dashboard is flat, dry, and free from dirt and dust. Peel off the protective sheet from the adhesive side of the pad (see step 2A), and press the pad against the dashboard so that it stays firmly in place. When you peel off the ENGLISH protective sheet from the pad, do not touch the adhesive side. Rotate the ring on the mounting device clockwise (2D) to create a vacuum between the suction cup and the pad. To detach the suction cup from the pad, proceed in the same way as when you detach the cup from a windscreen (9, 10, and 11). Attach the holder to the mounting device To attach the mobile holder to the mounting device, insert the catch on the mounting device into the slot at the back of the holder (see step 2E). [. . . ] The following suggestions will help you protect your warranty coverage. · Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. [. . . ]